Beverage enterprises for blow molding machine has two urgent demand because of plastic raw material prices continued to rise, beverage enterprises are constantly thinking about how to reduce packaging costs to achieve the profit maximization, so need advanced blowing bottle production equipment lighter weight bottles using; the second is due to the rapid changes in the market, beverage production enterprises must be to drink more and shorter life cycle to make flexible response, and is increasingly frequent products in the production of PET bottle problem, in the production process requires the replacement of the mold to a minimum. These two urgent needs to blow bottle equipment suppliers out of a no small problem.

Closed loop (Loop Closed) technology is to refer to the process parameters of the connection check is integrated in the process control system of the stretch blow molding machine, which forms a closed, automatic control and automatic regulation. The intelligent machine control technology is designed to improve the quality assurance system of the bottle blowing machine. Through the use of AgrPETWallplus monitoring system can monitor and control the various kinds of data, such as bottle wall thickness. At work, deviated from the rated value data will be immediately identifiable. This information will be timely delivery to the blowing machine bottle preform heating unit control system, the control system will quickly reflect and individually controlled heating furnace in the heating lamp of ratings. Therefore, even if the data of each bottle is different, in the initial set of process parameters remain unchanged, the production of the bottle quality is still stable and reliable.

Maintenance and maintenance

1 feeding position does not need to be checked for several conditions:

If there is no feed hopper, and if it is: need to hurry up

Not: please check lifting machine control contactor whether in electrified state, if it is to state, as soon as possible to check the electrical whether in power and load state, because the situation is likely to be by the bottle blank (embryo) stuck in the elevator, then the simplest method is artificial help ascending.

If checking hoist machine control contactor not in electrified state, please check the bottle embryo electric eye detection whether and the reflecting plate is not in a straight line.

2 feeding old card feeding plate: this situation is a headache problem, from the experience to see if the bottle billet (embryo) the length of the relatively long cut weight, then this phenomenon is relatively small.

3 bottles can not be removed from the mold after blowing.

Should first open molds, with manual opening and closing of the mould, if normal, with empty running status, if also normal.

Please check your exhaust time settings, if normal exhaust setting, and every time as long as the blowing bottle fault words, then can judge is the exhaust valve, please open the exhaust valve and check the spring and sealing parts (there is a phenomenon of the fault is with high exhaust sound and has no net voice).

If you encounter is a lot of mold production normal accidental to the open mode, please check the locking pin whether section of the screw on the inside. Also, please check mode locking force is too big, if too much should be rearranged according to standard.

4 bottles are always caught.

Position of manipulator is misplaced.

5 two mechanical hand collision

This situation requires a re manual reset manipulator, is due to dislocation caused by

5, can replace the DC speed control and servo control

PETBottle blowing machineProfessional manufacturerASNTO| SNTO |Plastic bottle blowing machine|Huangyan Zhejiang plasticA machinery plant