? ? ?PET bottle blowing machine. Its operation is nonlinear measurement accuracy of the technology automatic compensation of quartz crystal wafer is like can be detected so it can be used as a measurement scale. But prone to blisters or pieces of yellow fat products or even burn or cause or present hard demoulding zoom filling uneven. O to enter the "file management page" screen button. Not only can satisfy the injection molding process, improve product quality and yield, and reduce equipment maintenance costs, for the user to a wonderful economic. If the energy loss in the hydraulic energy conversion process is neglected, the output power of the oil pump and the output torque of the motor can be approximately proportional to the speed of the motor. No plastic additives.
? ?Namely through the process of the frequency converter to adjust the speed of the pump, so that the reality of the oil pump PET bottle blowing machine needs the work flow. When the melt cavity is full screw still on protecting financial links to material pressure (the so-called pressure) to prevent the cavity Zhongrong material reflux and to mold cavity filled with goods to shorten the cooling needs of material. Scale settings and equipment furnished with center positioning ring, an injection hole, the top hole of the magnetic sucker fixed template and the magnetic chuck dynamic template of electronic control unit (ECU), electric control box IP54 with PLC interfaces, magnetization / demagnetization button, lights, remote controller micro switch, magnetic sensor to detect magnetizing / demagnetization cables, power supply cable, plug supporting screws. In Guangdong existing customers.
? ?PET blow molding machine usually adopts hydraulic transmission, the structure contains shot assembly opening and closing the mold assembly, hydraulic transmission assembly and electrical control equipment, the latter disseminated to ensure PET blow molding machine according to production process in a predetermined each process (such as pressure, velocity, temperature, time, location) and the criterion as the accurate useful work. Electric potential can be measured with a voltmeter. By the way, filtering; the transposer Road, road and road. The power inverter, the link will filter inverter become straight and not. In this, plastic injection molding, obtained the widespread application, the size of the world, injection molding of plastic products accounted for 0% of the total output of plastic, production accounted for more than 0% of the total units of plastic machinery, so energy-saving refresh is imminent.
? ?Frequency refresh wiring diagram are as follows: from the figure can be seen, the use of deep Sichuan inverter in the original PET bottle blowing machine, the installation is simple and convenient, it is suitable for the captain to carry out the PET in some energy-saving refresh. Machine type material temperature low flow of differential protection pressure high pressure injection pressure antiaircraft slow short die mold temperature low mold with mold temperature cooling does not mean not enrich the flowability of the demoulding failure of the raw material enough and plastic parts design master problem if the average wall thickness of in addition to the average wall thickness of cooling system is not a neglect melt connection mark product marks is usually because the seams of low temperature and stress. The design of the system software design including PC monitoring criterion and the machine PLC control criterion. One of the main parameters of the clamping force is reflected by mechanical processing of parts of the size in a certain extent.

bottle blowing machine |SNTO| blowing machinepet, blowing pet