? ?Rotary bottle blowing machine with high-speed, stable, fast and easy replacement of the advantages of a fast, well received by the customers, the market share of a straight line. Below, I will rotate the bottle blowing machine some common fault treatment method, and we make the exchange discussion.
? ?Problem one: the high pressure solenoid valve can not be effectively closed and the production of high-pressure gas leak. The reason is that the high pressure solenoid valve inside the sealing ring where the card has a foreign body, the majority of plastic debris. This is required to open the high pressure solenoid valve sealing ring for cleaning, to restore the normal use of the installation.
? ?Problem two: when the bottle out of the bottle. The reason is out of the bottle or not live clip fingers automatically open the bottle, need to replace the fingers inside the nylon block.
? ?Question three: when the billet out of the double billet. The reason is that the gap between the billet and the slab is too large to adjust the gap to the right.
? ?Problem four: draw the upper limit of the seal alarm. Three reasons: low pressure gas pressure is not enough; five two solenoid valve work is not sensitive; relay damage. Solution: 1, to ensure low pressure gas is 0.6 - 0.8MP; 2, solenoid valve and check and cleaning (replacement) of low-pressure air filter replacement; 3, replace the relay (transient electric control box in the other idle relay to replace).
? ?Question five: open mold clamp from the bracket. The reason is a deviation from the center of the mold, fixture rotary die a collision caused, as long as the adjustment bracket position.
? ?Question six: when the billet is not on the bottle blank holder. The reason is that the fixture center is not concentric with the center of the billet. Solution: 1, such as eight of the dial wheel and clamp are not correct, then adjust the position of the dial wheel; 2, such as the individual clamp and dial wheel gap is not correct, then check the guide axis is not bent, if there is, it is necessary to replace the guide shaft.
? ?Problem seven: finished product rate decreased significantly. The reason is the heating lamp damage; heating lamp switch tripping; ventilation motor or air motor trip. Solution: 1, replace the damaged heating lamp tube; 2, check the corresponding switch in the electric control box, close the trip of the switch, such as frequent trips, to find electrical solutions.

bottle blowing machine |SNTO| blowing machinepet, blowing pet